TCS 1
Beam Clamp TCS 1 M10/M10 A4
Group: 1737
Part number 116568
Solid connecting element for mounting pipes, ducts and devices on steel profiles
Combination with Universal Joint ss enables vertical alignment on inclined beams
Technical Data
B | 33 mm |
B1 | 21,5 mm |
H1 | 26,2 mm |
L | 44 mm |
L2 | 23 mm |
Ma | M10 |
Mi1 | M10 |
Mi2 | M10 |
Pre-assembled with clamping bolt and locking nut.
Load range
-VZ,perm. | 5,00 kN |
The nominal loads indicated apply to new Beam Clamps fixed to undamaged beam flanges only.
Technical specifications
Material base body | Stainless Steel A4 |
Corossion class | CRC II – III (C4 – C5 acc. to DIN EN ISO 12944-2) |
Certification
Installation
Tighten the clamping bolt of the Beam Clamp first by hand, then tighten down with a spanner according to the mounting instructions. The hardened point of the clamping bolt will penetrate the comparatively soft material of the beam, ensuring a solid and highly secure connection. Tighten the locking nut for securing the installation.
Use an additional Holding Bracket HK 41 for mounting in the aera of the cutting edge of a channel.
Clamping range on parallel flange: 26 mm
Advice: Read relevant mounting instructions before installation!