STA F 80-E

End Support STA-E F 80 HCP

Group: A422

Part number 192863

Plug-in component designed to create an endplate at the open end of a Beam Section TP F80 or a Cantilever Bracket AK F80

Round holes in the base plate allow direct connection to existing cast-in channels

Technical Data

Documents

Approvals / ETA

siFramo - ETA-24/0471
PDF (2.15 MB)

B_P	80 mm
H_P	190 mm
L_G	148 mm
t_P	8 mm

Load range

-V_X,perm.	17,00 kN
V_X,perm.	17,00 kN
-V_Y,perm.	9,10 kN
V_Y,perm.	9,10 kN
V_Z,perm.	31,30 kN

-M_X,perm.	2,1 kNm
M_X,perm.	2,1 kNm
M_Y,perm.	2,3 kNm
-M_Z,perm.	0,8 kNm
M_Z,perm.	0,8 kNm

The specified load values are design loads Rd and include a partial safety factor γM2 = 1.25 (DIN EN 1993-1-8:2025-04, Table 4.1)
A partial safety factor of γG = 1.35 (DIN EN 1990:2021-10, Table A1.2(B)) must be taken into account for permanent loads.

Technical specifications

Primary element material	steel
Surface finish	HCP
Corrosion protection class	C4

Also available with DualShield for high corrosion protection within C5H environments.

Installation

Type STA F 80-E:
Depending on the version, following mountings solutions are possible:
a) With 2x4 Self Forming Screws FLS when used to connect 2 Beam Sections.
b) With 4 Self Forming Screws FLS applied to the octagonal insert and 2 suitable wall anchors/fixings when connected to the building structure.
The Beam Section TP F 80/80 connected to the End Support STA F 80 has to be screwed with 4 Self Forming Screws FLS F. On each of the opposite sides 2 Self Forming Screws FLS F are necessary.
Configuration: Base plate welded to octagonal element F 80

Type STA F 80/30-E:
The Beam Section TP F 80/30 E connected to the End Support STA F 80/30 E has to be screwed with 2 Self Forming Screws FLS F.