Channel Holder MOF 27 MV
Group: 2753
Used to create crossbars between channel or as a base for a single-arm cantilever
Suitable for Channel MS 27/15 and 27/25
Overview of Types
General Information
To be used for installing crossbars between two Channels MS 27 or as base unit for projecting channels. Note: When assembling version MH as cantilever, consider sufficient bracing of the channel. In case of tension load F _z at channel slot, screws must be displaced.
Certification
Technical specifications
Material base body | steel |
Surface | electro galvanized (Fe//Zn) |
Corossion class | C2 |
Load range
Type | -VX,perm. |
MOF MV27 | 0,80 kN |
Type | -MY,perm. | MY,perm. |
MOF MV27 | 0,08 kNm | 0,08 kNm |
Software
This product is available in the following software.
Installation
Position the channel into the U-profile. Click in the Speed Nut by pushing on the bolt head and tighten with 10 Nm.
Documents
Datasheets / Loads
- Anchor Loads - Channel Holder MOF 27
PDF (0.10MB)