End Support STA F100-F100/160 HCP

Group: A822

Part number 114878

End Support enables flexible design options in combination with brackets or profiles

Compatible with F 100 and F 100/160 profiles for a wide range of applications

Technical Data

B_P	100 mm
H_P	270 mm
L_G	239 mm
t_P	8 mm

Load range

-V_X,Rd	44,5 kN
V_X,Rd	44,5 kN
-V_Y,Rd	54,8 kN
V_Y,Rd	54,8 kN
-V_Z,Rd	42,1 kN
V_Z,Rd	42,1 kN

-M_Y,Rd	3,5 kNm
M_Y,Rd	3,5 kNm
-M_Z,Rd	2,1 kNm
M_Z,Rd	2,1 kNm

The specified load values are design loads Rd and include a partial safety factor γM2 = 1.25 (DIN EN 1993-1-8:2025-04, Table 4.1)
A partial safety factor of γG = 1.35 (DIN EN 1990:2021-10, Table A1.2(B)) must be taken into account for permanent loads.

Technical specifications

Primary element material	steel
Surface finish	HCP
Corrosion protection class	C4

Also available with DualShield for high corrosion protection within C5H environments.

Installation

Type STA F 100 and 100-80:
Depending on the situation, different options are recommended:
a) With 2x4 Self Forming Screws FLS when used to connect 2 Beam Sections.
b) With 4 Self Forming Screws FLS applied to the octagonal insert and 2 suitable wall anchors/fixings when connected to the building structure.
The Beam Section TP F 100/100 connected to the End Support STA F 100 has to be screwed with 4 Self Forming Screws FLS F. On each of the opposite sides 2 Self Forming Screws FLS F are necessary. Alternatively with two suitable wall anchors through holes “A” when fixed directly to building structure.
Configuration: Base plate welded to Octagon F 100 or F 80

Type STA F 100-100/160:
For the connection to Beam Section TP F 100 or TP F 100/160 (flange side 100) 4 Self Forming Screws FLS F are necessary.
The Beam Section TP F 100/160 connected to the End Support STA F 100 - 100/160 has to be screwed with 8 Self Forming Screws FLS F. On each of the broader sides 4 Self Forming Screws FLS F are necessary.
Configuration: Base plate welded to Octagon F 100/160