M12-25/125
Resin Anchor Rod VMZ-A A4
Group: 1738
Stainless steel anchor rod for push-through and pre-positioned mounting in concrete tensile zones for heavy loads in M&E services and plant construction
Suitable for attaching pipelines, channels and brackets in closed rooms (except damp locations)
No special drill required, small edge and centre distance
Overview of Types
General Information
Stainless Steel Anchor Rod for push-through and put-before mounting in concrete tensile zones in M&E services and plant construction (for anchoring heavy loads). Suitable for attaching pipelines, channels, brackets, etc. in closed rooms - except for damp locations. No special drill required. Small edge and centre distance. Approved for use under seismic action according to the performance category C1 and C2.
Certification
Sikla Approval ETA-15/0260
Technical specifications
Material base body | Stainless Steel A4 |
Class | A4-70 |
Corossion class | CRC II – III (C4 – C5 acc. to DIN EN ISO 12944-2) |
Fire resistance
Type | FRP 30 | FRP 60 | FRP 90 | FRP 120 |
VMZ-A 80 M12-25/125 A4 | 9,86 kN | 4,59 kN | 1,86 kN | 0,56 kN |
Software
This product is available in the following software.
Installation
1. Drill hole according to min. setting depth vertically to the surface.
2. Careful cleaning of drill hole with Steel brush and Blow-Out Pump.
3. Screw Mixing Nozzle onto the cartridge; foreshots to be removed and fill 2/3 of drill hole with resin starting from botton of the hole.
4. Drive the anchor manually into plastered borehole up to its embedment mark.
5. When reaching the embedment mark, plaster must be apparent.
6. Respect hardening time, when tighten the anchor with instructed torque.
Detailed assembly instruction is attached to the product.
Documents
- Injection System VMZ - ETA 10/0260
PDF (6.64MB)
- Sikla Anchor Injection Systems
PDF (8.81MB)
- DoP - Injection System VMZ
PDF (8.42MB)