Speed Nut NT CC41 HCP
Group: 1814
Particularly useful for installation in vertical channels or where access is difficult
Can be used in all Sikla Channels of 27 mm width, independent of the channel's height
HCP coating meets special corrosion protection requirements
Overview of Types
General Information
In particular useful for installation in vertical channels or where access is difficult. Further advantages: Can be used in all Sikla Channels of 27mm width, independent of the channel's height. No getting stuck on bolt heads when sliding in the channel. No appearance of settlement after tightening. The HCP coating meets special corrosion protection requirements.
Certification
Technical specifications
Material base body | steel |
Material connecting element | Spring steel, stainless |
Class | 5.6 |
Surface | HCP |
Corossion class | C4 |
Load range
Type | VX,perm. | -VZ,perm. |
NT CC41-M 6 HCP | 0,90 kN | 3,20 kN |
NT CC41-M 8 HCP | 2,10 kN | 5,80 kN |
NT CC41-M10 HCP | 3,40 kN | 5,80 kN |
NT CC41-M12 HCP | 9,00 kN | 10,00 kN |
The permissible load capacities of the channels are to be respected.
Software
This product is available in the following software.
Installation
After inserting the Speed Nut into the channel opening, it is turned to the right as far as it will go by exerting slight pressure on it; deinstallation may be effected by following the instructions on the reverse order.
Installation and deinstallation do not require tools and may be repeated several times.
| M6 | M8 | M10 | M12 | |
|---|---|---|---|---|
| Tightening torque 8.8 [Nm] | 10 | 25 | 40 | 80 |
Using lower steel classes, the value are to be reduced accordingly.