GE F100 - 80 Q
Pivot Joint GE F100 q HCP
Group: A437
Bracing element for single-arm cantilevers with System siFramo 100 and for reinforcement of frame constructions
For type F100–F80, TP F80 beam section is used; for type F100–F100, TP F100 beam section is used
Angle continuously adjustable between 25° and 155°
Overview of Types
General Information
Applicable as bracing element of single-arm cantilevers in conjunction with System siFramo 100 and for the reinforcement of frame constructions. For type F 100 - F 80, a TP F 80 beam section is used for reinforcement. For type F 100 - F 100, a TP F 100 beam section is used. The angle a is continuously variable between 25° and 155°.
Certification
Technical specifications
Material base body | steel |
Surface | HCP |
Corossion class | C4 |
Load range
Type | -VX,perm. | VX,perm. |
GE-Q F100-F100 HCP | 16,50 kN | 16,50 kN |
Also available with DUALSHIELD for high corrosion protection within C5H environments.
Software
This product is available in the following software.
Installation
Attachment of the Joints to Beam Section TP F 100 by means of 4 Self Forming Screws FLS F at the base plate. The support profile TP F 80 or TP F 100 (depending on joint type) plugged onto the octagon is also attached by means of 4 Self Forming Screws, so 8 Self Forming Screws are necessary in total.
After installation at the desired angle the screws have to be tightened with 40 Nm.
Angle: 25° - 155°