Resin Anchor Rod VMU-A A4
Group: 1738
Stainless steel anchor rod for pre-installation with Injection Systems VMU plus, VME plus and VMH
Suitable for anchoring in concrete or in brickwork only with VMU plus, with adjustable embedment depth
Designed for indoor and outdoor use
Overview of Types
General Information
Stainless steel Anchor Rod for pre-installation, to be used with Injection Systems VMU plus, VME plus and VMH. For anchoring in concrete or in brickwork only with VMU plus. Due to the variable anchoring depth the effective embedment depth can be adjusted to the requested load. Suitable for indoor and outdoor use. No special drill required. Small edge and centre distances. Approved for use under seismic action according to the performance categories C1 and C2 (depending on the mortar).
Certification
Sikla Approval ETA-15/0270, ETA-17/0307
Approval ETA 17/0716, 19/0483
Technical specifications
Material base body | Stainless Steel A4 |
Class | A4-70 |
Corossion class | CRC II – III (C4 – C5 acc. to DIN EN ISO 12944-2) |
Detailed technical information see respective injection systems.
Software
This product is available in the following software.
Installation
1. Drill hole according to min. setting depth vertically to the surface.
2. Careful cleaning of drill hole with Steel brush and Blow-Out Pump.
3. Screw Mixing Nozzle onto the cartridge; foreshots to be removed and fill 2/3 of drill hole with resin starting from botton of the hole.
4. Drive the anchor manually into plastered borehole up to its embedment mark.
5. When reaching the embedment mark, plaster must be apparent.
6. Respect hardening time, when tighten the anchor with instructed torque.
Image: h(ef) + t(fix) = usable length of the threaded rod (without nut and washer)
Detailed assembly instruction is attached to the product.
Documents
- Sikla Anchor Injection Systems
PDF (8.81MB)