Profile Coupling PK F 80 HCP

Group: A430

Internal splice connecting element for Beam Section TP F 80, particularly suitable for vertical extension

For horizontal application, the bending moment must be considered

Select a Type

Overview of Types

General Information

Internal splice connecting element for Beam Section TP F 80, particularly suitable for vertical extension. Should the component be used for horizontal application, the bending moment needs to be considered.

Certification

Technical specifications

Primary element material	steel
Surface finish	HCP
Corrosion protection class	C4

Load range

Type	-V_X,perm.	V_X,perm.
PK-4KT F 80 HCP	10,00 kN	10,00 kN
PK-8KT F 80 HCP	10,00 kN	10,00 kN

Type	-M_Y,perm.	M_Y,perm.	-M_Z,perm.	M_Z,perm.
PK-4KT F 80 HCP	5,09 kNm	5,09 kNm	5,09 kNm	5,09 kNm
PK-8KT F 80 HCP	3,54 kNm	3,54 kNm	3,54 kNm	3,54 kNm

The specified load values are design loads Rd and include a partial safety factor γM2 = 1.25 (DIN EN 1993-1-8:2025-04, Table 4.1)
A partial safety factor of γG = 1.35 (DIN EN 1990:2021-10, Table A1.2(B)) must be taken into account for permanent loads.

Also available with DualShield for high corrosion protection within C5H environments.

Software

This product is available in the following software.

Installation

To be fastened with 2 x 4 FLS F Self Forming Screws. For optimal bending moment, distance between screws to be as far from each other as possible.

Notice:
Self Forming Screw FLS F to be fastened on two sides with a distance of minimum of 100mm (for type 4kt) / 50 mm (for type 8kt) and to be fastened symmetrically. To optimise the bending moment the FLS F should be installed to maintain the pipe weight of the effective flow - i.e. screws are located top and bottom for horizontal cross bars not sideways.