Speed Nut NT CC41 HCP
Group: 1814
Assembly aid for vertical rails or hard-to-reach places – effectively replaces a ‘third hand’.
Can be used universally in all Stainless steel Sikla mounting rails with a rail width of 41 mm – regardless of the rail height.
HCP coating meets special corrosion Protection requirements.
Overview of Types
General Information
In particular useful when installing in vertical channels or in places of difficult access. Further advantages: for all Sikla Channels MS 41, independent of the height of the channel, no getting stuck on bolt heads when sliding in the channel, no appearance of settlement after tightening. The HCP coating meets special corrosion protection requirements.
Certification
Technical specifications
Primary element material | steel |
Connecting element material | Spring steel, stainless |
Class | 5.6 |
Surface finish | HCP |
Corrosion protection class | C4 |
Load range
Type | VX,perm. | -VZ,perm. |
NT CC41-M12 HCP | 9,00 kN | 10,00 kN |
The permissible load capacities of the channels are to be respected.
Software
This product is available in the following software.
Installation
After inserting the Speed Nut into the channel opening, it is turned to the right as far as it will go by exerting slight pressure on it; deinstallation may be effected by following the instructions on the reverse order.
Installation and deinstallation do not require tools and may be repeated several times.
| M6 | M8 | M10 | M12 | |
|---|---|---|---|---|
| Tightening torque 8.8 [Nm] | 10 | 25 | 40 | 80 |
Using lower steel classes, the value are to be reduced accordingly.