Type MA
Assembly Set MS 5P MA M12 S HCP
Group: A640
Part number 114886
Used to connect a Beam Bracket TKO, Angled Beam Bracket SKO, End Support WBD or Pivot Joint GE F
Suitable for mounting on a beam section
Technical Data
b | 13 mm |
d | 13 mm |
4 Beam Clips M12
4 Support plates M12
4 Stop plates M12
4 HR trimmings M12 x 80
HR trimming according EN 14399-3 consisting of: Hexagon bolt M12, 2 washers, 1 hexagon nut
Load range
-VY,perm. | 32,90 kN |
VY,perm. | 32,90 kN |
-VZ,perm. | 15,10 kN |
VZ,perm. | 15,10 kN |
The specified F(z) data relate to the worst case with flange thicknesses 30 mnm (M12) or 40 mm (M16) as well as a coefficient of adhesion µ(adhesion) = 0,20.
A possibly operating tensile force F(y) isn't included.
Technical specifications
Material base body | steel |
Surface | HCP |
Corossion class | C4 |
Certification
Installation
1. Position stop plate on component to be mounted.
2. Position the Beam Clip with the slit side into the indentations of the stop plate and with the lug on the steel girder.
3. Install support plate and HR trimming and tighten accordingly.
The support plate secures a rectangular assembly of the bolt and prevents its shifting or bending stress. In conjunction with the HR trimming a continuous and predictable preload force is guaranteed. The stop plate ensures a tight fit of the Beam Clip.
Tightening torques:
| Type | Size range [mm] | Tightening torque MA [Nm] / plus revolution |
|---|---|---|
| M12 MA S | 1 - 30 | 60 / 90° |
| M16 MA S | 4 - 40 | 140 / 90° |